ResMed AirFitP10 Gebrauchsanweisung Seite 7

• Using a mask may cause tooth, gum or jaw soreness or aggravate
an existing dental condition. If symptoms occur, consult your
physician or dentist.
• As with all masks, some rebreathing may occur at low CPAP
pressures.
• Refer to your CPAP or bilevel device manual for details on
settings and operational information.
• The mask is not intended to be used simultaneously with
nebulizer medications that are in the air path of the mask/tube.
• Remove all packaging before using the mask.
Note: For any serious incidents that occur in relation to this device, these
should be reported to ResMed and the competent authority in your
country.
Using your mask
When using your mask with ResMed CPAP or bilevel devices that have
mask setting options, refer to the Technical specifications section in this
user guide for mask selection options.
For a full list of compatible devices for this mask, see the Mask/Device
Compatibility List at ResMed.com/downloads/masks.
Notes:
• This mask is not compatible for use with ResMed AutoSet CS™ 2 and
VPAP™ Adapt SV devices.
• SmartStart may not operate effectively when using this mask with
some CPAP or bilevel devices that have this feature.
• If you experience nasal dryness or irritation, using a humidifier is
recommended.
Fitting
1. Hold the pillows away from your nose ensuring that the pillow size
(eg, M) with the left (L) and right (R) indicators are correctly facing
towards you then guide the nasal pillows into your nostrils (L into your
left nostril, R into your right nostril). Pull the headgear over your head
by holding the bottom band and stretching it around the back of your
head. The top band should sit comfortably on top of your head.
Tip! There are raised logos on top of the frame so you can feel the
correct way up when fitting in the dark.
English 3