Daily Use - Washing & Drying - Zanussi ZWT 71401 WA Benutzerhandbuch

• Each time you press this button the time
value increases by 5 minutes.
• As the appliance calculates also the
duration of the anti-crease and the cooling
phases, the programme time will
automatically increase by some minutes.
2. Press button to start the programme.
• The display shows regularly a new time
value.
• The indicator
If you set only 10 minutes of drying,
the appliance performs only a cooling
phase.
If the laundry is not sufficient dry, set again a short
drying time.
END OF THE DRYING PROGRAMME
The appliance stops automatically.
• The acoustic signals operate (if they are active).
DAILY USE - WASHING & DRYING
WARNING! Refer to Safety chapters.
NON-STOP PROGRAMME (AUTOMATIC
WASHING & DRYING)
For NON-STOP programme the recommended
load size is 3 kg for cotton and 2 kg for synthetic.
CAUTION! Do not use a dosing
device/ball when carrying out a
washing and drying programme.
1. Load the laundry one item at a time.
2. Put the detergent and the additives in the
appropriate compartment.
3. Turn the programme knob to the required
programme to switch the machine on.
4. Set the available options.
To have a good drying performance
do not exceed the maximum drying
loads recommended in the user
manual. Do not set a spin speed
lower than the automatic speed of the
set programme.
WASHING & TIMED DRYING
To have a good drying the appliance does not let
you set a too low spin speed for the items to be
washed and dried.
14
is on.
• In the display comes on.
• The indicator of the
• The last minutes of the drying cycle the
appliance performs a cooling and anti-crease
phase. The door is still locked. The display show
a flashing .
When the door locked indicator
can open the door.
1. Turn the programme knob to
deactivate the appliance.
After some minutes from the end of the programme,
the energy saving function automatically
deactivates the appliance.
2. Remove the laundry from the appliance.
Make sure that the drum is empty.
3. Keep the door ajar, to prevent mildew and
odours.
4. Close the water tap.
1. Press the button
value.
After some seconds the display shows the final
time value, that is the total duration of the washing
and drying cycles (washing + drying + anti-crease
+ cooling phases).
If you set only 10 minutes of drying
after washing, the appliance calculates
also the duration of the anti-crease
and the cooling phases.
2. Press button to start the programme.
The indicator comes on. The door is locked.
The display shows regularly a new time value.
END OF THE PROGRAMME
The appliance stops automatically. The acoustic
signals operate (if they are active).
For more information see 'At the end of the drying
programme " of the previous chapter.
1. Turn the selector dial to the position
switch the machine off.
2. Remove the laundry from the appliance. Make
sure that the drum is empty.
3. Keep the door ajar, to prevent mildew and
odours.
4. Close the water tap.
button goes off.
goes off, you
position to
to set the drying time
to