Frost Precautions - Zanussi ZWT 71401 WA Benutzerhandbuch

2
1
• Screw the pump cover firmly. Turn it clockwise.
CAUTION! When the appliance is in
use and depending on the set
programme there can be hot water in
the pump.
Never remove the filter during a washing cycle,
always wait until the appliance has finished the
cycle, and is empty.
When refitting the filter, ensure it is securely re-
tightened so as to stop leaks and young children
being able to remove it.
CLEANING THE INLET HOSE AND THE VALVE
FILTER
If the appliance doesn't fill, take long to fill with
water, the starting button blinks or the display (if
available) shows the relevant alarm (see chapter
'Troubleshooting' for more details), check if the
water inlet filters are blocked.
To clean the water inlet filters:
1
2
3
• Screw the hose back onto the tap. Make sure
the connection is tight.
18
• Put the cap back on
the emergency empty-
ing hose and place
the latter back in its
seat.
• Replace the filter into
the pump, insert it
correctly into the spe-
cial guides.
• Turn off the water tap.
• Unscrew the hose
from the tap.
• Clean the filter in the
hose with a stiff brush.
• Unscrew the hose
from the machine.
• Keep a rag nearby be-
cause some water
may flow.
45°
20°

FROST PRECAUTIONS

If the appliance is installed in an area where the
temperature can be less than 0° C, remove the
remaining water from the inlet hose and the drain
pump.
1. Disconnect the mains plug from the mains
socket.
2. Close the water tap.
3. Place the end of the emergency emptying hose
and that of the inlet hose in a bowl placed on
the floor and let water flow out of the hoses.
4. Set the Drain programme and let it operate until
the end of the cycle.
5. Turn the programme knob to
the appliance from the power supply.
6. Screw the water inlet hose back on and re-fit
the emergency emptying hose after having put
the cap on again.
WARNING! Make sure that the
temperature is more than 0 °C before
you use the appliance again.
The manufacturer is not responsible
for damages caused by low
temperatures.
• Clean the filter in the
valve with a stiff brush
or with the piece of
cloth.
• Screw the hose back
to the machine and
make sure the con-
nection is tight.
• Turn on the water tap.
to disconnect