Setting A Programme - Zanussi ZWT 71401 WA Benutzerhandbuch

DETERGENT COMPARTMENTS
Detergent compartment for pre-
wash phase.
Detergent compartment for
washing phase.
Compartment for liquid additives
(fabric conditioner, starch).
USING DETERGENT AND ADDITIVES

SETTING A PROGRAMME

1. Turn the programme knob to switch the
appliance on and set the programme:
• The indicator of the button
• The display shows the programme duration.
2. If necessary, change the temperature and the
spin speed or add available options. When you
activate an option, the indicator of the set
option comes on.
If you set something incorrect, the
display shows the message
STARTING A PROGRAMME WITHOUT THE
DELAY START
Press the button
• The indicator of the button
flash and stays on.
• The programme starts, the door locks, the
indicator
• The programme starts and the door locks.
• The programme time decreases with steps
of one minute.
The drain pump can operate for a
short time at the beginning of the
washing cycle.
STARTING A PROGRAMME WITH THE DELAY
START OPTION
12
1. Measure out the de-
tergent and the fabric
conditioner.
2. Put the detergent
and the fabric condi-
tioner into the com-
partments.
3. Carefully close the
detergent drawer.
flashes.
.
stops to
is on.
1. Press the button
display shows the delay you want to set. The
delay start indicator comes on.
2. Press the button
• The door is locked and the indicator
on.
• The appliance starts the countdown.
• When the countdown is completed, the
programme starts automatically.
You can cancel or change the set of
the
button
option.
To cancel the
a. Press the button
to pause. The indicator of button
flashes.
b. Press the button
above this button goes off.
Press the button
programme immediately.
CANCELLING A RUNNING PROGRAMME
1. Turn the programme knob to position
cancel the programme and to deactivate the
appliance.
.
2. Turn the programme knob again to activate the
appliance. Now, you can set a new washing
programme.
Before starting the new programme
the appliance could drain the water. In
this case, make sure that the detergent
is still in the detergent compartment, if
not fill the detergent again.
INTERRUPTING A PROGRAMME AND
CHANGING THE OPTIONS
You can change only some options before they
operate.
1. Press the button
The indicator flashes.
2. Change the options.
3. Press the button
The programme continues.
again and again until the
:
option before you press the
. After pressing the button
you can only cancel the
option:
to set the appliance
until the indicator
again to start the
.
again.
is
to