Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Read the manual and follow the instructions relating to
safety tips, correct and complete product assembly,
setting into service, use and maintenance.
For your own safety, always heed the advice and
warnings in these instructions.
Non-compliance with these operating instructions may
expose you to serious danger. Only use the product in
the places and conditions for which it is intended.
• ATTENTION! NO PROTECTION AGAINST
DROWNING!
• SWIMMERS ONLY!
• Full inflate all air chambers.
• Passenger numbers and load weight shall by no
means exceed passenger number and maximum
weight capacity in specifications.
• This product should not be used as life saving device.
• Life saving device (life jacket and life buoy) must be
prepared together and inspected.
• Keep away from flames and fires.
• Before every use, carefully inspect all product
components, to ensure everything is in good condition
and tightly secured. Please stop to repair if you find
any damage.
• Be careful when landing on the ground. Sharp and
rough objects such as rocks, cement, shells, glass,
etc. may punctured the product.
• Don't leave the product exposed to sun for long
periods of time, as high temperatures shall give rise to
air expansion, which can cause irreparable damage.
• Never leave in or near the water when not in use.
• Evenly distribute loads when use the product. Tipping
and drowning may occur with uneven distribution of
loads.
INFLATION
1. Before using the product, carefully check if there are
any leaks or broken parts.
Open valve and inflate with the air pump (not
include) to design working pressure on the product.
2. Fill the chambers until most of the wrinkles are gone
and it feels firm to touch but NOT hard. If you use
other pressure gauge, the pressure should not be
more than the specified pressure on the product or
on the instruction. Do not over-inflate the product. Do
not use an air compressor.
NOTE: Under and over-inflation of the product will
result in safety hazards. It is better to check the
pressure of the product each time before using.
WARNING
3. Be sure to close the valves after inflation, press in
the safety valves after inflation.
NOTE: Never stand on or rest objects on the product
during inflation. Always check product for leaks
before use.
DEFLATION
REPACKING
1
d
3
5
d
7
NOTE: Drawing for illustration purpose only. May not
reflect actual product. Not to scale.
MAINTENANCE AND STORAGE
1. After deflation, use a damp cloth to gently clean all
surfaces.
NOTE: Never use solvents or other chemicals that
may damage the product.
2. Store in a cool, dry place and out of children's reach.
3. Check the product for damage at the beginning of
each season and at regular intervals when in use.
Please use this float by placing the side marked with a
printed warning up, while facing the other side toward
the water.
5
2
a
e
e
a
c
b
4
d
a
c
b
6
e
b
8
d
e
a(c)
b
Werbung
Inhaltsverzeichnis
