Merax MS196018 Bedienungsanleitung Seite 30

Running belt specialized lubricant
This electric treadmill's running board and running belt has been lubricated in factory. Friction
between the running belt and running board has a great influence to the using life and the performance
of the electric treadmill, therefore regular applying of lubricant is needed. We advise you to check the
board regularly. If the board's surface is damaged, please contact our customer service center.
We advise using lubricant between running belt and running board with following schedule:
Lightweight user (use less than 3 hours a week) once per month;
Heavyweight use (use more than 7 hours a week) once every half month.
In order to better safeguard your electric treadmill and extend the life of the machine, it is
1.
recommended that after your continued use of two hours, turn off the machine and let it rest for 10
minutes before using again.
If the treadmill belt is too loose, there will be skid phenomenon while running; if it's too tight, it
2.
may reduce motor performance and harden the abrasion of roller and the running belt. You can lift
two sides of the running belt for 50-75mm when the tightness is appropriate.
Running with adjusted alignment and tightness
In order to better use the treadmill and make the treadmill functions work better, it is necessary for
you to adjust the running belt into the best condition.
Running Belt alignment
 Put electric treadmill flat on the ground.
 Make the electric treadmill run at a speed of about 6-8km/hour.
 If the running belt is closer to the right, rotate the right adjusting bolt with 1/2 turn counter-
clockwise, then rotate the left adjusting bolt with 1/2 turn clockwise. (Picture B)
 If the running belt is closer to the left, rotate the left adjusting bolt with 1/2 turn counter-
clockwise, then rotate the right adjusting bolt with 1/2 turn clockwise. (Picture A)
Picture A Picture B
12