Bushnell VAULT Bedienungsanleitung Seite 3

You are the proud owner of the
Bushnell Vault™ Modular Optics Protection System Binocular Pack.
The Vault™ Binocular Pack is the first truly modular binocular harness pack that makes it easy to protect and access
your glass in the field. The Vault's magnetic closure securely keeps your binos in the pack when closed, allowing you to
confidently move around in spot and stock situations and keep the binos in the pack even when upside down. In addition,
the Vault has mesh pockets with an elastic band on both sides for a wind checker and mouth calls, as well as a padded
slip pocket on the back for your mobile phone or documents. Along with the addition of the Vault LRF pouch that uses the
same dynamic features, having your range finder and binoculars readily accessible and protected close at hand.
Some of the thoughtful design features include:
• QUIET, MAGNETIC CLOSURE WITH EASY, ONE-HAND ACCESS
Magnetic closure makes it easy to access and protect your glass quickly without making noise. The closure is designed
to open with one hand towards the front so that you don't have to fight the flap.
• DURABLE, SOFT-TOUCH FABRIC REDUCES NOISE IN THE FIELD
Soft-touch material prevents sounds from movement in the field, ensuring you don't blow your position. The material
is water resistant. The inside of the pack is lined with lens cleaning cloth material that will protect your glass.
• SLEEK, COMPACT DESIGN WITH MODULAR CAPABILITIES
The compact design makes it easy to carry what you need without getting in the way of your movement. MOLLE
webbing on the bottom of the pack allows a pistol or bear spray holster to be mounted.
• ULTRALIGHT, COMFORTABLE, AND MODULAR HARNESS
The fully-featured harness is an easy-to-use comfortable design. Offset buckles allow the harness to clip into itself,
creating a stand-alone harness that can be used if the pack is not needed.
• FITS UP TO 12x50 ROOF BINOCULARS
Tested to fit Bushnell™ roof optics up to 12x50 configuration. For smaller binoculars, the included riser allows them to
sit at the top of the pack making it easier to pull out.
FITTING YOUR VAULT BINO PACK:
1. Attach your binocular by threading the small ends of the Binocular Attachment
Straps into your binocular's strap slugs, see image below. Put the attached
binoculars in the Vault and proceed to custom fit the Vault to your preference.
2. To successfully fit your Vault, we recommend buckling the two Shoulder
Straps into the top harness buckles and click one of the Waist Straps into the
corresponding buckle at the bottom of the pack. Slip the harness over your head
and make adjustments to the shoulder straps by sliding the webbing through the
plastic slides for height placement and comfort of the pack on your chest.
3. After adjusting the shoulder straps, attach the second waist strap by buckling
it into the bottom of the bino pack. Now, make adjustments to the waist straps by
threading the webbing through the plastic slides on the waist straps for comfort
and security.
4. Adjust the Binocular Attachment Straps by threading them through the shoulder
strap plastic slides. Adjust until your glass is at a comfortable length when hanging
down and holding up to your eyes.
Binocular Attachment Straps
Thread the small strap
ends of the Binocular
Attachment Straps to
your binocular.
Thread the large strap ends of the
Binocular Attachment Straps to your
Shoulder Straps.
Shoulder Straps
Waist Straps
3