Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Air supply requirements
•
Supply tool with a maximum pressure according to the technical data mentioned in this
instruction manual or mentioned on the name plate of clean, dry air.
•
Connect the tool to air line using pipe, hose and fitting suitable for this tool.
•
Please consult the technical data in this instruction manual.
Instruction of use
•
Please make sure that if the tool is fitted with a torque/air regulator, that the torque
achieved complies with the application.
Pneumatic tool and safety instructions
•
The goal of Bendel Werkzeuge is to offer tools that help your work safely and efficiently.
•
The most important safety device for this or any tool is YOURSELF.
•
Your care and good judgment are the best protection against injury. All possible hazards
cannot be considered here, but we have tried to highlight some of the most important
ones.
•
This tool may only used by qualified people.
•
This tool and its accessories must not be modified.
•
Do not keep the Tire-Booster in use or under pressure while carrying it.
•
Maintain a firm grip on the power tool and position your body and arm to allow you to
resist kickback forces. The operator can control torque reactions or kickback forces, if
proper precautions are taken.
•
Switch off the unit immediately in case of blocking or twist. Disconnect the air supply and
do not switch on again until the problem is solved. Understand the reason why the tool
has been blocked and make sure that this situation will not occur once more by
counteract accordingly.
Air supply and connection hazards:
•
Air under pressure can cause several injury !
•
Always shut off air supply, drain hose of air pressure and disconnect tool from air supply,
when not in use, before changing accessories or maintenance.
•
Never put direct air at yourself or anyone else.
•
Whipping hoses can cause serious injury. Always check for damaged or loose hoses
and fittings.
•
Do not exceed maximum air pressure according on the name plate.
14
Werbung
