Herunterladen Inhalt Inhalt Diese Seite drucken

How To Remove And Install: Door - AEG BD782S Benutzerinformation

Vorschau ausblenden Andere Handbücher für BD782S:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 184
CARE AND CLEANING

11.11 How to remove and install: Door

You can remove the door and the internal glass panels to clean it. The number of glass panels
is different for different models.
WARNING!
The door is heavy.
CAUTION!
Carefully handle the glass, especially around the edges of the front panel. The
glass can break.
Step 1
Fully open the door.
Step 2
Lift and press the clamping
levers (A) on the two door
hinges.
Step 3
Close the oven door to the first opening position (approximately 70° angle). Hold the
door at both sides and pull it away from the oven at an upwards angle. Put the door
with the outer side down on a soft cloth on a stable surface.
Step 4
Hold the door trim (B) on the
top edge of the door at the
two sides and push inwards
to release the clip seal.
Step 5
Pull the door trim to the front
to remove it.
Step 6
Hold the door glass panels on
their top edge one by one and
pull them up out of the guide.
Step 7
Clean the glass panel with
water and soap. Dry the glass
panel carefully. Do not clean
the glass panels in the dish‐
washer.
Step 8
After cleaning, do the above
steps in the opposite se‐
quence.
Step 9
Install the smaller panel first, then the larger and the door.
Make sure that the glasses are inserted in the correct position otherwise the surface of
the door may overheat.
126/328
A
2
B
A
1

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Bse782280mBse78228bmBsk782280m

Inhaltsverzeichnis