Error Codes - Life & Mobility PRESTO Gebrauchsanleitung

Inspired by life
Faults
General
Attention:
Never attempt to resolve a fault yourself. Contact your dealer instead.
ƒ

Error codes

1. An abnormal condition may be indicated by a flash code on the display.
2. Depending on the condition, the scooter may or may not allow driving. In some
cases driving may be allowed but in a reduced speed („limp") mode.
3. See table below for error codes, the meaning and way to solve the issue.
4. Contact your dealer to repair the error if resetting does not help.
5. Pass the error message on to your dealer.
Flash Description Meaning
1 Battery Low The batteries are running low or are in an overdischarged state.
• Recharge the batteries.
2 Low Battery Fault The batteries have run out of charge.
• Recharge the batteries.
• Check the battery and associated connections and wiring.
3 High Battery Fault Battery voltage is too high. This may occur if overcharged &/or travelling
down a long slope.
• If travelling down a slope, reduce your speed to minimise the amount of
regenerative charging.
4 Current Limit Time-out The motor has been exceeding its maximum current rating for too long.
or Controller too hot • The scooter may have stalled. Turn the controller off, leave for a few
minutes and turn back on again.
• The motor may be faulty. Check the moto and associated connections and
wiring.
5 Park Brake Fault Either a park brake release switch is active or the park brake is faulty.
• Check the park brake and associated connections and wiring.
• Ensure any associated switches are in their correct positions.
6 Drive Inhibit Either a Stop function is active or a Charger Inhibit or OONAPU condition
has occurred.
• Release the Stop condition (seat raised etc.)
• Disconnect the Battery Charger
• Ensure the throttle is in neutral when turning the controller on.
• The Throttle may require re-calibration.
7 Speed Pot Fault The throttle, speed limit pot, SRW or their associated wiring may be faulty.
• Check the throttle and speed pot and associated connections and wiring.
8 Motor Voltage Fault The motor or its associated wiring is faulty.
• Check the motor and associated connections and wiring.
9 Other error The controller may have an internal fault.
• Check all connections and wiring.
* The Scooter and R-Series produce the same flash code sequences to indicate a fault, but the flash timings are different:
Scooter flash timings: 250ms ON / 500ms OFF with a 2s break between.
R-Series flash timings: 140ms ON / 400ms OFF with a 2.4s break between.
EN32
Terms and Conditions of Warranty
The Life & Mobility products are made with care and
are carefully inspected before leaving the factory.
Should it emerge that a product does not meet
expectations please contact the party where you
purchased the product. Life & Mobility respects the
laws and regulations that protect the consumer and
that apply in the country in which the product is
purchased.
The warranty does not apply to defects caused
by: failure to observe the instructions for use and
maintenance, use other than normal use, wear and
tear, negligence, overloading, third-party accidents,
non-original parts used and defects not caused by the
product.
This warranty replaces any other warranty, either
stipulated by law or communicated orally, except for
anything guaranteed in writing by Life & Mobility.
Warranties are only valid within the EU.
Warranty
EN33