Settings And Adjustments - Life & Mobility PRESTO Gebrauchsanleitung

Inspired by life

Settings and adjustments

You can set up the mobility scooter to meet
all your requirements. It is advisable to contact
your dealer for the correct settings.
Adjusting the seat
Seat height
The seat is connected tot the seat post with a
bolt-nut connection and can be adjusted by
your dealer
Back angle
Attention:
ƒ Only adjust the backrest when you are sitting
in the seat.
ƒ Watch out for overturning:
- If you have set up the seat with a large back
angle.
- When driving up a slope.
- If the slide system is in the rear-most
position.
1. Sit down on the seat.
2. Lift up the lever (N).
3. Use your upper body to push the backrest
backwards into the right position, or:
4. Bend your upper body forward to allow the
backrest to move forward automatically.
5. Release the lever (N).
The backrest is now locked in its current
position.
EN16
N
Armrests
L Attention:
ƒ
M
Armrest angle
1. Rotate the armrest upwards. (L)
2. Release the nut and thighten the bolt (M) to
Change armrest angle
3. Fix the nut to secure the bolt.
Armrest width
1. Release the knob (M2) to adjust the armrest
M1
M2
M1 Armrest height
M2
1. Release the knob (M1) to adjust the armrest
Steering column angle
1. Sit down on the seat.
2. Pull the lever up (T)*.
3. Pull the steering column towards you or push
4. Release the lever.
T
* It is located on the left or right-hand side,
Change handlebar angle
The position of the armrests changes if the
position of the backrest is adjusted.
rotate the armrest downward or loosen the
bolt to rotate the armrest upward.
sideways. Fix the knob when correct position
is reached.
in height. Fix the knob when correct position
is reached.
it away until you reach the desired position.
The steering column is now locked in place.
depending on the configuration of your
mobility scooter.
EN17