Operating Times; Operation - Wolf Garten UL 33 E Gebrauchsanweisung

Operating Times

Please check noise abatement regulations prevailing in your Country.
Assembly
Assembling bottom handle part (fig. M1)
Insert securing screw (A) from inside through the left side element, so that both projections catch in the recesses (1). Position insulation
element (B) from outside; the two nubs must catch in the holes of the side element (2). Position handle element (M) in the insulating element
(B). Place insulating element (C) so that the large opening points to the outside. Then press washer (D) into the opening of the insulating
element (C) and tighten wing nut (G).
Assemble the right handle element in the same order.
Assembling top of handle (fig. M2)
Attach upper handle element (N) on the lower handle elements (M), making sure that the holes (1) match. Then insert the connecting screws
from outside, put on the washers (F) and tighten the wing nuts (G).
Attaching switch, strain relief and clips (fig. M3)
Fold up switch bracket (1) and position switch (H) on the upper handle element so that the two nubs catch in the holes (2). Close switch
bracket (1) and insert cable strain relief (I). Then fasten switch (H) and cable strain relief (I) with the two screws (K). Fasten switch cable (3)
with the clips (L) on the handle rod.
Attaching protective flap (fig. M4)
Place protective flap (O) on the cover (1). Then press retainer slots (2) into the fastening flaps (3) on the cover (1).

Operation

General
Before using the machine, the lawn must be mowed to a height of about 2.5-3.5 cm. Remove the cut grass from the lawn. The lawn should be
aerated several times each year. The loosened material can be removed with a rake or catch bag*. Afterwards, the lawn should be fertilized.
* Accessories at additional cost.
Setting the working depth (Fig. B1)
The working depth is adjustable to 3 heights. Pull adjustment arm (1) away from side
cover and allow to catch in desired position (2). Adjust the height alternately left and right
by only 1 position. The adjustment arms must always be in the same height position.
Lower and middle position of aerator cylinder:
Removes moss and weeds from the lawn.
Top position of aerator cylinder:
Removes grass remnants from the lawn.
Insert connection cable in the strain relief (fig. B2)
Insert coupling of connection cable (3) in the socket of the switch (H). Then guide the cable (4) from outside in a slight loop over the peg (5)
of the strain relief assembly (I).
Connection to the power outlet
(230 Volt AC, 50 Hz). The machine can be connected to any power outlet that is protected by a 10 amp fuse (or line protecting switch type K
- formerly H).
Note:
Use a residual current protection device with a residual current of no more than 30 mA.
Motor on (fig. B2)
Press button (1) and hold.
Lift lever (2) and release button (1).
Motor off (fig. B2)
Release lever (2).
Attaching catch bag* (fig. B3)
Lift protective flap (O). Hang catch bag (1) with the hooks on both bolts** of the side elements.
(* TK 33, accessory at additional cost, ** bolts included with catch bag)
8
Recommended working depths
height Moss Grass-
(mm) Weeds remnants
-3 X ---
4 X ---
8 --- X