Makita DC64WA Betriebsanleitung Seite 5

Charging
1. Plug the battery charger into the proper AC volt-
age source. Charging lights will flash in green
color repeatedly.
2. Insert the battery cartridge into charger until it
stops while aligning the guide of charger.
3. When the battery cartridge is inserted, the
charging light color will change from green to
red and charging will begin. The charging light
will keep lighting up steadily during charging.
One red charging light indicates charged condi-
tion in 0–80 % and red and green ones indicate
80–100 %. The 80 % indication mentioned above
is approximate value. The indication may differ
according to battery temperature or battery
condition.
NOTE: Charging time varies by temperature (10°C (50°F)–40°C (104°F)) that battery cartridge is charged at and
conditions of the battery cartridge, such as a battery cartridge which is new or has not been used for a long period
of time.
Voltage
57.6 V - 64 V
(max.)
NOTICE:
The battery charger is for charging Makita-battery cartridge. Never use it for other purposes or
for other manufacturer's batteries.
NOTE: If the charging light flashes in red color, charging may not start due to the condition of the battery cartridge
as below:
— Battery cartridge from just-operated tool or battery cartridge that has been left in a location exposed to direct
sunlight for a long time.
— Battery cartridge that has been left for a long time in a location exposed to cold air.
NOTE: When the battery cartridge is too hot, charging does not begin until the battery cartridge temperature
reaches the degree at which charging is possible.
NOTE: If the charging light flashes alternately in green and red color, charging is not possible. The terminals on
the charger or battery cartridge are clogged with dust or the battery cartridge is worn out or damaged.
Number of cells Li-ion battery cartridge
32
4. When charging is finished, red and green charging
lights will change to one green light.
5. After charging, remove the battery cartridge from
charger while pushing the hook.
Then unplug the charger.
NOTE: If the hook does not open smoothly, clean
dust around mounting parts.
► Fig.2: 1. Hook
Capacity (Ah)
according to IEC61960
BL6440
5 ENGLISH
Charging time
(Minutes)
4.0 120