Corrective Action; Maintenance And Service; Maintenance, Cleaning And Storage - Bosch Keo Originalbetriebsanleitung

OBJ_BUCH-1453-005.book Page 15 Wednesday, April 1, 2015 2:21 PM
Problem Possible Cause
Excessive vibra- Power tool defective
tions/noise
Sawing time per bat- Blade holder area needs cleaning
tery charge too low
Saw blade has worn
Poor sawing technique
Battery not fully charged
The saw blade is run- Battery is getting discharged
ning slow
On/Off switch is not fully pressed
Overloaded during operation
Green and red LED Battery temperature is out of charging range Increase or reduce the battery temperature to within the
flash alternately
Red LED flashes 1x Battery voltage is too low, battery is empty Recharge battery; also see "Battery Charging"
Red LED flashes 2x Battery temperature is out of operating
range
Red LED flashes fast Overload (jammed blade)
5x

Maintenance and Service

Maintenance, Cleaning and Storage

 Before any work on the machine (e. g. maintenance,
changing the tool, etc.) as well as during its transport
and storage, lock the On/Off switch in the off position.
There is danger of injury when the On/Off switch is unin-
tentionally actuated.
 Always remove the blade before any work on the ma-
chine.
 For safe and proper working, always keep the machine
and ventilation slots clean.
Clean the saw blade holder preferably with compressed air or
a soft brush. Remove the saw blade from the power tool for
this. Ensure proper operation of the saw blade holder by ap-
plying a suitable lubricant.
Heavy contamination of the machine can lead to malfunc-
tions. Therefore, do not saw materials that produce a lot of
dust from below or overhead.
Store the power tool in a secure, dry place, out of the reach of
children.
Do not place other objects on the power tool.
After-sales Service and Application Service
www.bosch-garden.com
In all correspondence and spare parts order, please always in-
clude the 10-digit article number given on the type plate of
the machine.
Bosch Power Tools

Corrective Action

Contact Service Agent
Hold the tool to point to the ground and start to operate
Change saw blade
see "Working Advice" (figure 8)
Recharge battery; also see "Battery Charging"
Recharge battery; also see "Battery Charging"
Fully press On/Off switch
Reduce pressing force of tool against branch
specified range between 0 °C and 45 °C
Increase or reduce the battery temperature to within the
specified range between –15 °C and +65 °C
Reduce pressing force of tool against branch
Operate tool before the blade touches the branch
Great Britain
Robert Bosch Ltd. (B.S.C.)
P.O. Box 98
Broadwater Park
North Orbital Road
Denham
Uxbridge
UB 9 5HJ
At www.bosch-pt.co.uk you can order spare parts or arrange
the collection of a product in need of servicing or repair.
Tel. Service: (0344) 7360109
E-Mail: boschservicecentre@bosch.com
Ireland
Origo Ltd.
Unit 23 Magna Drive
Magna Business Park
City West
Dublin 24
Tel. Service: (01) 4666700
Fax: (01) 4666888
Australia, New Zealand and Pacific Islands
Robert Bosch Australia Pty. Ltd.
Power Tools
Locked Bag 66
Clayton South VIC 3169
Customer Contact Center
Inside Australia:
Phone: (01300) 307044
Fax: (01300) 307045
Inside New Zealand:
Phone: (0800) 543353
Fax: (0800) 428570
Outside AU and NZ:
Phone: +61 3 95415555
www.bosch.com.au
English | 15
F 016 L81 219 | (1.4.15)