Herunterladen Inhalt Inhalt Diese Seite drucken

Corrective Action - Bosch AKE 30-19 S Betriebsanleitung

Vorschau ausblenden Andere Handbücher für AKE 30-19 S:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 7
OBJ_BUCH-1238-001.book Page 35 Friday, April 30, 2010 9:39 AM
When bucking on a slope, always stand on the
uphill side of the log. When "cutting through",
release the cutting pressure near the end of the
cut without relaxing your grip on the chain saw
handles in order to maintain complete control.
Troubleshooting
The following chart lists problem symptoms, possible causes and corrective action, if your machine
does not operate properly. If these do not identify and correct the problem, contact your service
agent.
Warning: Switch off and remove plug from mains before investigating fault.
Problem
Possible Cause
Chain saw fails to
Kickback brake is activated
operate
Plug not connected
Mains socket faulty
Fuse faulty/blown
Extension cable damaged
Chain saw operates
Mains cable defective
intermittently
External or internal wiring defect Contact your Bosch Service Centre
On/Off switch 2 defective
Saw chain dry
No oil in reservoir
Vent in oil filler cap 4 clogged
Oil passage clogged
Brake does not stop
Kickback brake/run-down brake
saw chain
defective
Saw chain/guide bar
No oil in reservoir
hot
Vent in oil filler cap 4 clogged
Oil passage clogged
Chain tension too high
Dull saw chain
Chain saw rips,
Chain tension too loose
vibrates, does not saw
Dull saw chain
properly
Chain worn out
Chain teeth are facing in the
wrong direction
Bosch Power Tools
Don't let the chain contact the ground. After
completing the cut, wait for the saw chain to
stop before you move the chain saw. Always
stop the chain saw motor before moving from
tree to tree.

Corrective Action

Pull activation lever for kickback brake
(hand guard) 5 back in position
that the red dot 28 is covered
Connect plug
Use another socket
Replace fuse
Try without extension cable
Check mains cable and have it
replaced, if required
Contact your Bosch Service Centre
Refill oil
Clean oil filler cap 4
Clean oil passage
Contact your Bosch Service Centre
Refill oil
Clean oil filler cap 4
Clean oil passage
Adjust chain tension
Sharpen saw chain or replace
Adjust chain tension
Sharpen saw chain or replace
Replace saw chain
Reassemble with chain in correct
direction
F 016 L70 667 | (30.4.10)
English | 35
, so

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Ake 40-19 sAke 35-19 s

Inhaltsverzeichnis