Herunterladen Inhalt Inhalt Diese Seite drucken

Residual Risks; Machine Information - Ferm CDM1165 Bersetzung Der Originalbetriebsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 8
b) Use power tools only with specifi cally
designated battery packs. Use of any other
battery packs may create a risk of injury and fi re.
c) When battery pack is not in use, keep it
away from other metal objects, like paper
clips, coins, keys, nails, screws or other
small metal objects that can make a
connection from one terminal to another.
Shorting the battery terminals together may
cause burns or a fi re.
d) Under abusive conditions, liquid may be
ejected from the battery; avoid contact.
If contact accidentally occurs, fl ush with
water. If liquid contacts eyes, additionally
seek medical help. Liquid ejected from the
battery may cause irritation or burns.
e) Do not use a battery pack or tool that is
damaged or modifi ed. Damaged or modifi ed
batteries may exhibit unpredictable behaviour
resulting in fi re, explosion or risk of injury.
f) Do not expose a battery pack or tool to
fi re or excessive temperature. Exposure to
fi re or temperature above 130 °C may cause
explosion. NOTE The temperature „130 °C"
can be replaced by the temperature „265 °F".
g) Follow all charging instructions and do not
charge the battery pack or tool outside
the temperature range specifi ed in the
instructions. Charging improperly or at
temperatures outside the specifi ed range may
damage the battery and increase the risk of fi re.
6) Service
a) Have your power tool serviced by a
qualifi ed repair person using only identical
replacement parts. This will ensure that the
safety of the power tool is maintained.
b) Never service damaged battery packs.
Service of battery packs should only be
performed by the manufacturer or authorized
service providers.
Additional safety warnings for drills
and screw drivers
a) Hold the power tool by insulated gripping
surfaces, when performing an operation
where the cutting accessory or fasteners
may contact hidden wiring. Cutting
accessory contacting a "live" wire may make
exposed metal parts of the power tool "live"
and could give the operator an electric shock."
Safety instructions when using long
drill bits
a) Never operate at higher speed than the
maximum speed rating of the drill bit.
At higher speeds, the bit is likely to bend if
allowed to rotate freely without contacting the
workpiece, resulting in personal injury.
b) Always start drilling at low speed and with
the bit tip in contact with the workpiece.
At higher speeds, the bit is likely to bend if
allowed to rotate freely without contacting the
workpiece, resulting in personal injury.
c) Apply pressure only in direct line with the bit
and do not apply excessive pressure. Bits
can bend causing breakage or loss of control,
resulting in personal injury.

Residual risks

Even when the power tool is used as
prescribed it is not possible to eliminate all
residual risk factors. The following hazards
may arise in connection with the power tool's
construction and design:
a) Health defects resulting from vibration
emission if the power tool is being used
over longer period of time or not adequately
managed and properly maintained.
b) Injuries and damage to property to due to
broken accessories that are suddenly dashed.
Warning! This power tool produces an
electromagnetic field during operation.
This field may under some
circumstances interfere with active or
passive medical implants. To reduce the
risk of serious or fatal injury, we
recommend persons with medical
implants to consult their physician and
the medical implant manufacturer before
operating this power tool.

2. MACHINE INFORMATION

Intended use
The impact driver is intended for driving in and
loosening screws and bolts.
Not suitable for construction site usage.
5

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis