Outdoor Temperature; Reset To Factory Default Settings - Hyundai Wsp 3080 R Wind Bedienungsanleitung

• Reset the maximum indoor humidity value. When both the indoor humidity value and MAX
icon are flashing, hold the ENTER key for 3s, the maximum indoor humidity value will be
reset to current reading.
• Reset the minimum indoor humidity value. When both the indoor humidity value and MIN
icon are flashing, hold the ENTER key for 3s, the minimum indoor humidity value will be
reset to current reading.

Outdoor temperature

- Press the MENU key the tenth time to select the OUTDOOR TEMPERATURE section
OUTDOOR TEMPERATURE section digits will start flashing. Enter the outdoor temperature
display mode, press the UP/+ or DOWN/- key to Select the outdoor temperature display
between Outdoor Temperature, Wind Chill and Dew Point.
- Press ENTER key to select the following modes:
Temperature unit display. Press the UP/+ or DOWN/- key to select the temperature unit
•
between °C and °F.
The outdoor temperature high alarm setting. Press the ON/OFF key to on/off the alarm.
•
If alarm is enabled, an alarm symbol
has been enabled.
• The outdoor temperature low alarm setting. Press the ON/OFF key to on/off the alarm.
If alarm is enabled, an alarm symbol
has been enabled.
• Reset the maximum outdoor temperature value. When both the outdoor temperature value
and MAX icon are flashing, hold the ENTER key for 3s, the maximum outdoor temperature
value will be reset to current reading.
• Reset the minimum outdoor temperature value. When both the outdoor temperature value
and MIN icon are flashing, hold the ENTER key for 3s, the minimum outdoor temperature
value will be reset to current reading.
Outdoor humidity
- Press the MENU key the eleventh time to select the OUTDOOR HUMIDITY section.
- Procedures and settings are similar to Indoor humidity.
Memory modes
1) Press the HISTORY key to activate history data toggle display, Press DOWN/- key to toggle
forward to see earlier weather history data together time stamp, press UP/+ key to see later
history weather data. When history data displayed, the corresponding time will be displayed
at the time section area ( History data saving interval can only be changed using the PC
software that comes with this product, the default history data saving time interval is preset
to 30 minutes prior to shipment).
2) Press the ENTER key again will trigger the memory clear procedure: the word of "CLEAR"
will be flashing; the full memory usage icon will be flashing. Hold the ENTER key for 3 seconds
will clear the memory.

Reset To Factory Default Settings

While in normal display, press and hold the UP/+ key for 20seconds to reset all settings to the
manufacturer default settings.
appears in the display indicating the alarm function
appears in the display indicating the alarm function
EN - 80