Care And Cleaning; General Information; Cleaning The Hob; Troubleshooting - Leonard LAI6001F Benutzerinformation

Heat setting

CARE AND CLEANING

WARNING! Refer to Safety
chapters.

General information

• Clean the hob after each use.
• Always use cookware with a clean
base.
• Scratches or dark stains on the surface
have no effect on how the hob
operates.
• Use a special cleaner suitable for the
surface of the hob.
• Use a special scraper for the glass.

Cleaning the hob

• Remove immediately: melted plastic,
plastic foil, sugar and food with sugar,

TROUBLESHOOTING

WARNING! Refer to Safety
chapters.
What to do if...
Problem
You cannot activate or oper‐
ate the hob.
Use to:
Boil large quantities of water. PowerBoost is activated.
Possible cause
The hob is not connected to
an electrical supply or it is
connected incorrectly.
The fuse is blown.
You do not set the heat set‐
ting for 10 seconds.
Time Hints
(min)
otherwise, the dirt can cause damage
to the hob. Take care to avoid burns.
Use a special hob scraper on the glass
surface at an acute angle and move the
blade on the surface.
• Remove when the hob is sufficiently
cool: limescale rings, water rings, fat
stains, shiny metallic discoloration.
Clean the hob with a moist cloth and a
non-abrasive detergent. After cleaning,
wipe the hob dry with a soft cloth.
• Remove shiny metallic
discoloration: use a solution of water
with vinegar and clean the glass
surface with a cloth.
Remedy
Check if the hob is correctly
connected to the electrical
supply. Refer to the connec‐
tion diagram.
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
Activate the hob again and
set the heat setting in less
than 10 seconds.
Leonard 13