Ipfc Installation - Pentax IPFC-Serie Betriebsanleitung

5. IPFC installation

IPFC can be installed directly on the fan cover of the motor or mounted on the wall.
Motor mounting kit
In this application IPFC is cooled by the motor fan. Motor kit (available upon request) allows a solid coupling of the two units
and it is composed of:
IPFC SIZE 1

n.°4 rods

n.°4 M5 nuts

n.° 4 hooks

n.° 1 cooling ring
Use the cooling ring for best cooling of IPFC during
operation. Warning: when using the cooling ring, the
cooling air of the motor is slightly warmer than without
the IPFC; if the resulting motor temperature exceeds the
indicated maximum allowable value, remove the cooling
ring, leaving the IPFC to be cooled by itself.
12
IPFC SIZE 2

n.° 4 M5 screws.

n.° 4 clamps

n.° 4 clips to add if necessary

n.°1 centre pin