Becker CentronicPLUS SC911 PLUS Montage- Und Betriebsanleitung Seite 22

With the programming button on the sensor
With brand new products, devices from another installa-
tion or products that have been restored to factory set-
tings, programming mode must be established before-
hand (see Establishing programming mode).
3s
3s
22 - en
Press the programming button for 3 seconds when it is ready to pro-
gram. The sensor performs a search and the indicator lamp continuously
changes colour. The sensor then switches to receiver selection and se-
lects the receiver with the best connection quality.
▻ The receiver confirms.
If you do not receive confirmation from the required receiver, press the
programming button to toggle between the available receivers until the
required receiver confirms.
▻ The sensor displays the current assignment status of the re-
ceiver via the indicator lamp.
Assignment status
Lights up yel-
low:
Lights up blue:
Lights up green: The receiver is assigned to the se-
Press the function/control button to change the assignment status of the
selected receiver. If the receiver is not yet part of the installation, it will be
added and assigned to the selected channel.
or
▻ The receiver signals once to confirm the channel assignment,
or signals twice to cancel the channel assignment.
▻ The sensor lights up accordingly to confirm the new assign-
ment status.
► The receiver is now part of the installation.
Then press the programming button for 3 seconds to change to normal
mode.
► The indicator lamp goes out.
The receiver is not yet part of the in-
stallation or is in the as-delivered
condition.
The receiver is not assigned to the
selected channel.
lected channel.