Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Audio player
The built-in audio player plays titles in MP3, WMA and WAV format from USB devices and SD(HC) memory
cards. Make sure the 3.5 mm jack is not connected; otherwise the audio player will be muted.
1)
Set the INPUT SELECT switch to the AUX 5 position to assign the signal of the audio player to the
master signal.
2)
Insert a USB device into the USB port and/or a memory card into the card slot (notched corner to the
left).
3)
After loading a data carrier, it is selected as the playback medium and the playback will start
automatically. The display indicates the playback source and the elapsed time of the current title in
minutes and seconds.
4)
Shortly press the [MODE] button to switch between the data carriers and Bluetooth operation.
5)
By long actuation of the buttons [VOL‒/
audio player. There are 30 steps available (indication "U01-U30").
6)
To interrupt the playback, press the button [► ]. The display indicates
press the button once again.
7)
By short actuation of the buttons [VOL‒/
direction.
8)
To remove a USB device, disconnect it from the USB port. To eject a memory card, slightly press it into
the slot until it comes out and can be removed. Prior to removing a device, always terminate the
playback with the [►II] button. Otherwise damage or loss of data may occur.
Setting up a Bluetooth connection with mobile devices
The audio player features a Bluetooth receiver allowing you to stream music wirelessly from your mobile
devices such as smartphones, tablets and notebooks.
1)
Press the [MODE] button (repeatedly) until the display indicates "
player will enter the pairing mode.
2)
Activate the Bluetooth function at the Bluetooth source. The DJP-900P is indicated by "
the display of the Bluetooth source. Pair the devices with each other.
3)
Now play music at the Bluetooth source as you normally would and the sound will come out of the
amplifier.
4)
The Bluetooth source may also be operated via the audio player. To interrupt or continue the playback,
press the button [► ].With the buttons [
Protective circuits
The integrated protective circuits prevent damage to the speakers and the amplifier. To prevent distortions in
case overload, the integrated level limiter reduces the input signal if the limit level is reached at the output. If
one of the other protective circuits is activated, the speakers are electrically separated from the amplifier:
• for a few seconds after switching-on until the speaker outputs are ready for operation
• in case of overheating of the amplifier
• in case of overload of the amplifier
• in case of DC voltage at a speaker output
• in case of a short-circuit at a speaker output
If the speakers are switched off during operation or if they are not ready for operation after switching on, the
amplifier has to be switched off and the cause of the fault has to be removed.
] and [VOL+/
] you can adjust the internal volume of the
] and [VOL+/
] you can skip titles in forward or backward
] and [
] you can skip titles in forward or backward direction.
17 • EN
. To start the playback again,
bLUE "
and a beep sounds. The audio
BLUETOOTH
" on
Werbung
Inhaltsverzeichnis
