Replacing The Batteries - sylvac Hi Cal 300 V2 Bedienungsanleitung

Err8
Err9
no.dAtA
Err.bt2
------

Replacing the batteries

Unscrew the fixing screw at the rear of the Hi_Cal base and remove the
battery cover | ergonomic handle to change batteries.
In case of 1st start after a power failure or complete discharge, it is necessary
to press at least 0.5s on the ON | OFF button to start.
Important : please only use NiMH rechargeable battery pack delivered by
Sylvac for battery replacement
Flash memory error. Restart the instrument
Critical flash memory error. Turn off the power, if no change,
contact the service department.
Transmission impossible
a. BT disconnected --> Connect the instrument
b. Incomplete login process --> Wait for 100% login
c. Buffer full --> Reconnect to empty the buffer
Bluetooth
module setup error, restart the instrument
®
Waiting for Bluetooth
®
to switch
0
module initialization. Press any button
E
23