Disposal; Troubleshooting - Zipper Maschinen ZI-ZSM600 Betriebsanleitung

16.4

Disposal

Observe the national waste disposal regulations. Never dispose of the machine, ma-
chine components or operating equipment in the residual waste. If necessary, contact
your local authorities for information regarding available disposal options.
If you purchase a new machine or equivalent equipment from your specialist dealer, he
is obliged in certain countries to dispose of your old machine properly.
17

TROUBLESHOOTING

Danger due to electrical voltage!
Handling the machine with connected power supply may result in serious injury or death.
 Always disconnect the machine from the power supply before maintenance or repair
work and secure it against unintentional reconnection.
Many possible sources of error can be eliminated in advance if the machine is properly connected to the
mains.
If you are unable to carry out the necessary repairs properly and/or do not have the required training,
always consult a specialist to solve the problem.
Trouble
Wrong rotation direction of
the saw blade
Machine does not start
Although the water pump
is switched on, water is not
conveyed
Unusual noises during
operation
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
WAR N I N G
Possible cause
• The conductive phases at
the connection plug and
the socket do not match
Disconnection in the cable
•
connection
A missing phase may
•
come to the electrical
network to which the ma-
chine is connected
E-Stop button may be
•
pressed
Water cooling failure
•
Strong noise emission
•
while cutting
Solution
• Swap two conductive phases, egg. L1 and L2,
at the connection plug.
Check the cable connection
•
• Check the fuses on main supply
• Check the button. If it is pressed release it by
turning it.
Check that there is enough water in the basin
•
to cover the filter.
Check whether the filter is clogged and clean
•
if necessary.
Check the saw blade for wear or damage.
•
Change the saw blade if necessary.
•
TROUBLESHOOTING
37
ZI-ZSM600