Hazardous Situations; Transport - Zipper Maschinen ZI-ZSM600 Betriebsanleitung

The power plug must be removed from the socket-outlet prior to any check or action carried
out at the machine!
Hazard due to machine defects
•
If one or more parts of the machine are defective, the use of the machine is prohibited. De-
fective parts must be replaced immediately. Only replacement parts which have been ap-
proved by the manufacturer may be used. It is prohibited to make any changes to the ma-
chine.
Hearing damage if the necessary hearing protection is not used
•
12.7.2

Hazardous situations

Due to the structure and construction of the machine, hazardous situations may occur which are
identified in these operating instructions as follows:
A safety instruction designed in this way indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
Such a safety instruction indicates a potentially hazardous situation which, if not avoided,
may result in serious injury or even death.
A safety instruction designed in this way indicates a potentially hazardous situation
which, if not avoided, may result in minor or moderate injury.
A safety note designed in this way indicates a potentially dangerous situation which, if
not avoided, may result in property damage.
Regardless of all safety regulations, your common sense and your appropriate technical aptitude/training
are and remain the most important safety factor in the error-free operation of the machine. Safe working
depends on you!
13

TRANSPORT

If you transport the machine with a vehicle, ensure that the load is secured appropriately!
Transport the machine in its packaging to the place of installation. To manoeuvre the machine in the
packaging, a pallet truck, forklift truck with the appropriate lifting force and a fork of at least 1200 mm
length can be used. The specifications can be found in the chapter Technical data. For proper transport,
also observe the instructions and information on the transport packaging regarding centre of gravity,
lifting points, weight, means of transport to be used as well as the prescribed transport position etc.
Ensure that the selected lifting equipment (crane, forklift, pallet truck, load sling, etc.) is in perfect
condition.
Lifting and transporting the machine may only be carried out by qualified personnel with appropriate
training for the lifting equipment used.
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
D AN G E R
WAR N I N G
C AU TI O N
N O TI C E
TRANSPORT
27
ZI-ZSM600