Inhaltsverzeichnis
Werbung
14.3
Cleaning
Cleaning: The use of paint thinners, gasoline, corrosive chemicals or abrasive cleaners
will result in damage to the surface!
Therefore:
14.4
Storage
If the machine more than a month is not used, please follow these instructions:
Entire remove fuel from the tank, fuel cock and carburetor.
Water from the tap and remove line (this is to do in cold weather after each use)
Remove spark plug, pour about 1 tablespoon of engine oil into spark plug hole
Engine switch to the OFF
Operate starter rope several times
Spark plug insert
Generator in a dry, well ventilated place, cover.
14.5 Disposal
Do not dispose of your waste in the ZI-BTS350. Contact your local authorities for
information regarding the available disposal options. Improper disposal can lead to
contamination of soil, ground water soil seepage of hazardous and noxious substances,
and thus reach finally through contaminated water into your food supply and your
health. Replace your old unit with a new one at your local dealer, is obligated to take
back your old equipment free of charge for the purpose of proper disposal.
15
TROUBLESHOOTING
Trouble
Engine will not start
Engine stops after
starting
Less engine power
Bade does not run
Blade runs bad
ZIPPER MASCHINEN GmbH
ZI-BTS350
When cleaning, use only mild detergent
Possible Cause
ON OFF switch to OFF
Fuel filter clogged
Great power tank empty
Spark plug is defective or loose
Spark plug gap set wrong
Idle speed too low
Clogged fuel filter
The fuel tank is empty
Dirty air filter
V-belt is defective
defective clutch
cutting wheel shaft
www.Zipper-Maschinen.at
N O T E
flange and nut.
TROUBLESHOOTING
Solution
Switch in the On position
Fuel filter change
Fill the fuel tank
Clean or replace spark plug
Check the correct setting
Adjust idle speed
Change the fuel filter
add fuel
Clean or replace air filter
Change belts
machine repair
Check ball
bearings, shaft,
Replace if defective
26
Werbung
Inhaltsverzeichnis
