Storage - Zipper Maschinen ZI-ZSM600 Betriebsanleitung

16.3

Storage

Store the machine in a dry, frost-proof and lockable place when not in use. Make sure that unauthorised
persons and especially children do not have access to the machine.
Improper storage can damage and destroy important components. Only store packed or
already unpacked parts under the intended ambient conditions!
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
Check the V-belt tension:
Use thumb pressure to check the flexibility of
the V-belt.
If this is within approx. 10-15mm no action is
necessary. If the flexibility is higher, the V-belt
must be retightened (V-belt tensioning) or
replaced.
Tensioning
• Loosen the four screws (4) that fix the motor.
• Push the motor in direction (+), to increase
the V-belt tension.
• Retighten the four screws (4).
• Check V-belt tension.
• If the belt tension is correct, reinstall the V-
belt cover (1) and fix it with the screws (2, 3).
Otherwise readjust the belt tension.
Change
• Loosen the four screws (4).
• Push the motor in direction (-), to decrease
the V-belt tension.
• Pull the old V-belts from the pulley and re-
place with new ones.
• Tension the V-belts.
• Check the V-belt tension.
• If the belt tension is correct, reinstall the V-
belt cover (1) and fix it with the screws (2, 3).
Otherwise readjust the belt tension.
NOTICES:
same time, never replace a single belt!
N O TI C E
Always change both V-belts at the
36
ZI-ZSM600