Exchange V-Belt; Storage; Disposal; Troubleshooting - HOLZMANN-MASCHINEN KAP305ECO Betriebsanleitung

17.2.8 Exchange V-Belt

2
1
17.3

Storage

Improper storage can damage and destroy important components. Only store
packed or unpacked parts under the intended ambient conditions!
When not in use, store the machine in a dry, frost-proof and lockable place to prevent the
formation of rust on the one hand and to ensure that unauthorised persons and in particular
children have no access to the machine.
17.4

Disposal

Observe the national waste disposal regulations. Never dispose of the
machine, machine components or operating materials (like oil,...) in residual
waste. If necessary, contact your local authorities for information on the
disposal options available.
If you buy a new machine or an equivalent device from your specialist
dealer, he is obliged in certain countries to dispose of your old machine
properly.

TROUBLESHOOTING

Danger due to electrical voltage! Manipulating the machine with the power supply
up can lead to serious injuries or death. Always disconnect the machine from the
power supply before carrying out any troubleshooting work!
Many possible sources of error can be excluded in advance if the machine is properly connected
to the mains.
If you are unable to carry out necessary repairs properly and/or do not have the required
training, always consult a specialist to correct/solve the problem!.
Fault
Machine doesn't start
Workpiece kick-back
Wrong cutting angle
Saw blade cuts the table
HOLZMANN MASCHINEN GmbH
4
N O T E
W A R N I N G

Possible cause

 No power supply
 Carbon brushes defect
 Motor defect
 ON-OFF-switch defect
 Dull saw blade
 Wrong assembled saw blade
Angular position not correct

 Incorrect setting of cutting depth  Adjust cutting depth
www.holzmann-maschinen.at
 Loosen screw (1)
 Remove belt cover (2)
 Loosen the belt tension by turning the
screws (4) counter clockwise!
 Change belts.
 Retighten the screws (4). Do not
overtighten!
 Replace the belt cover and tighten all bolts
Connect to mains

 Exchange carbon brushes
 Exchange motor
Repair switch

 Replace saw blade
 Check direction / assemble
Adjusting the angular position

TROUBLESHOOTING
Correction
35
KAP 305ECO