Operation; Initial Check Before Start; Locking / Unlocking The Machine Head In The Transport Position; Setting The Angular Position Of The Worktable - HOLZMANN-MASCHINEN KAP305ECO Betriebsanleitung

OPERATION

16.1 Initial check before start

 Check that the speed of the machine is lower than the max. permissible speed of the
saw blade used.
 Check saw blade rotation and saw blade dimensions to match the machine.
 Check that the saw blade guard works properly.
 Check whether the connection to a dust collection system is installed.
 Check whether the stops/fences are set correctly and the saw blade is tightened.
 Check whether the machine is fixed on the working plate or a machine stand.
 Check whether the saw blade can run freely.
16.2 Operation
16.2.1

Locking / unlocking the machine head in the transport position.

By slightly pressing down the machine head (34) and simultaneously removing the locking bolt
(11) from the motor holder, the saw is released from the lowest /transport position.
Note: Please hold the handle and guide the machine head slowly upwards until it reaches the
uppermost position. If the handle is released, the machine head will jump up due to the spring
preload. Press the machine head (34) downwards to engage and reattach the locking bolt (11).

16.2.2 Setting the angular position of the worktable

16.2.3 Setting the angular position of the machine head

HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
Release the locking handle (1) when it is
tightened, pull the locked position lever (2)
upwards and adjust the turntable to the
desired angle with the locking handle.
The angle position is indicated by the
pointer (3) on the turntable.
Return the locking handle to the closed
position to secure the turntable.
Release the angle lock (1). Pull the locking
pin (2) and by means of the handle (3) tilt
the machine head to the left or right until
the desired angle (pointer position (4)) is
reached. Retighten the angle locking lever
(1).
OPERATION
28
KAP 305ECO