Setting The Stops/Fences; Setting Cutting Depth / Cutting Depth Limiting; Setting The Workpiece Support; Connection To A Dust Collection System - HOLZMANN-MASCHINEN KAP305ECO Betriebsanleitung

16.2.4 Setting the stops/fences

16.2.5 Setting cutting depth / cutting depth limiting

16.2.6 Setting the workpiece support

16.2.7 Connection to a dust collection system

For dust extraction in closed rooms, connect a suction hose to the dust extraction nozzle and fix it
with a hose clamp. Connection dimensions according to technical data.
HOLZMANN MASCHINEN GmbH
The two adjustable stops (1 and 2) must be adjusted after
changing the machine head angle. To do this, loosen the
fixing screws (1 and 2a) and adjust the fences so that
there is a gap of at least 5 mm between the saw blade and
fence. Then retighten the fixing screws to fix the stops.
The cutting depth can be adjusted continuously with the
screw (2a). To do this, loosen the thumb nut (2) on the
screw (2a). Turn the screw (2a) in or out to set the desired
cutting depth. Then retighten the thumb nut (2).
The lowest cutting depth limit is adjusted by means of screw
1. To do this, loosen the nut (1a) and screw in the screw for
a deeper cutting position, screw out the screw for a higher
cutting position and then fix it again by tightening the nut
(1a).
The workpiece support (1,2) can be adjusted in its position
in relation to the table. To do this, loosen the screw (1a,
2a), pull out the workpiece support or move it to the rotary
table and then fix it in the required position by tightening
the screw (1a, 2a).
www.holzmann-maschinen.at
C A U T I O N
Before cutting, check that the stop bars and
the saw blade cannot collide. (simulated cut
with switch-off machine)
N O T I C E
Check the setting by performing a test cut.
OPERATION
29
KAP 305ECO