Switch Machine On-Off; Switch Laser On-Off; Operation Modes; Mitre Cuts - HOLZMANN-MASCHINEN KAP305ECO Betriebsanleitung

16.2.8 Switch machine ON-OFF

16.2.9 Switch Laser ON-OFF

16.3 Operation modes

16.3.1 Mitre cuts

Mitre are particularly suitable for cutting small workpieces (approx. 100 mm) to length.
 For cross-cut cuts, the sliding mechanism is fixed by the fixation screw (1) so that the saw
unit cannot slide forwards or backwards during the cut.
 Adjust the angle setting according to the desired operation and adjust the stops/fences
accordingly.
 Mark the cutting line (by laser).
 Place workpiece against stop/fence and table and fix with the clamp device.
 Move the machine head to the uppermost position.
 Switch on the machine and wait until the saw blade has reached full speed (approx. 5 sec.),
 Make the crosscut (move the machine head downwards) until it has reached the lowest
position.
 Move the machine head to the uppermost position.
Machine head is spring loaded, do not simply release the machine head, instead
move the handle upwards until the uppermost position is reached (rest position).
 Release the ON-OFF switch and wait until saw blade comes to stand still.
 Remove workpiece

16.3.2 Sliding cuts

Sliding cuts are suitable for cutting longer workpieces.
HOLZMANN MASCHINEN GmbH
Switch the machine ON:
Press the locking button (1) and then press and hold down
the ON/OFF button (2) on the handle.
Switch the machine OFF:
Release the ON-OFF switch (2)
Switch the laser on/off with switch (1).
Switch in position 0: Laser switched off
switch in position 1: laser switched on
N O T E
www.holzmann-maschinen.at
OPERATION
30
KAP 305ECO