Hazard Warnings; Transport - HOLZMANN-MASCHINEN KAP305ECO Betriebsanleitung

 After you have finished cutting, release the switch, hold the machine head down and wait for
the blade to stop before removing the cut part.
 Hold the handle firmly if you make an incomplete cut or release the switch before the machine
head is fully in the down position.
Instructions for the use of the LASER:
 Do not look directly into the laser beam with unprotected eyes.
 Never point the laser beam at reflective surfaces or persons or animals. Even a low-power
laser beam can cause eye damage.
 Never open the laser module. Unexpected exposure to the beam may occur.
 Do not replace the laser with another type of laser.
 Repairs to the laser may only be carried out by the laser manufacturer or an authorized
representative.

13.7 Hazard Warnings

Despite their intended use, certain residual risks remain. Due to the structure and construction of
the machine, hazardous situations may occur when handling the machines:
A safety instruction designed in this way indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
Such a safety instruction indicates a potentially hazardous situation which, if not
avoided, may result in serious injury or even death..
A safety instruction designed in this way indicates a potentially hazardous situation
which, if not avoided, may result in minor or moderate injury.
A safety notice designed in this way indicates a potentially hazardous situation which,
if not avoided, may result in property damage.
Irrespective of all safety regulations, their sound common sense and corresponding technical
suitability/training are and remain the most important safety factor in the error-free operation of
the machine. Safe working depends first and foremost on you!

TRANSPORT

For proper transport, follow the instructions and information on the transport packaging regarding
centre of gravity, attachment points, weight, means of transport to be used and prescribed
transport position, etc.
Transport the machine in its packaging to the place of installation. When lifting, carrying and
depositing the load, make sure that you are in the correct posture:
 Lifting, Depositing
Ensure stability when lifting / setting down (legs hip width).
Lift / lower load with bent knees and straight back (like weightlifter).
Do not lift / lower the load jerkily.
HOLZMANN MASCHINEN GmbH
D A N G E R
W A R N I N G
C A U T I O N
N O T I C E
www.holzmann-maschinen.at
TRANSPORT
26
KAP 305ECO