Yedoo Wolfer 28 Bedienungsanleitung Seite 8

Installation manual
The assembly procedure is
the same for all models, it
only di ers in details, see
accompanying pictures.
When tightening the
connections do not
exceed the specified
tightening torque.
3.
First, check if the front fork of the
scooter is turned in the proper direction
(the V-brake arms / wheel holders are
facing forward),
For the Wolfer and Wolfer RS models,
release the brake jaws by slightly turning
the lever. In case of the Trexx model,
release the brake wire from the housing
and release the brake arms.
EN
1.
Installing the wheels
Insert the quick release mechanism into
the wheel ensuring that on both sides of
the wheel the narrow ends of the springs
face the centre of the wheel. In case
the quick-release levers are of di erent
length, use the shorter one for the rear
wheel.
4a.
Direction
of rotation
Insert the wheel into the front fork so it
is exactly in the middle. Caution: When
inserting the wheel, ensure that the
arrow on the tyre sidewall points in the
direction of rotation when the scooter
is rolling forwards.
2.
3 5
2
1
4
6
Disc brakes - Trexx Disc
Put the separately packaged brake discs
on wheel hubs. Attach the rotor of the
disc brake so that the arrow on the rotor
would correspond to the rotation of the
wheel. Screw the rotor to the hub using
the attached key (torx).
When fastening the screws, make sure
you follow the sequence according to
the picture.
4b.
8