Yedoo Wolfer 28 Bedienungsanleitung Seite 10

Installation manual
7d.
Rear wheel installation (disc brake)
Put the wheel into the upper holder of
the fork, centre the wheel and fasten
the quick-release lever. It is not possible
to use the lower holder with the basic
setup of the scooter.
8b.
EN
8c.
8a.
1
Adjusting the height of the handlebars
Loosen the screws on the stem and
adjust the handlebars to the desired
height using spacer rings. To set the
handlebars to the lowest position,
turn the stem so it points downwards,
see fig. 8c.. After adjusting the
handlebar height, first tighten the head-
set screw (1), then the side screws (2, 3).
8d.
6–8 Nm
2
3
5–6 Nm
10