Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Specifications
Electrical Characteristics
Total Harmonic Distortion (THD+N)
Frequency Response
Hum & Noise (20 Hz - 20 k Hz)
Rs=150 ohms
Hum & Noise are measured with a 6 dB/octave
filter @12.7 k Hz; equivalent to a 20 k Hz filter
with infinite dB/octave attenuation.
Maximum Voltage Gain
Adjacent Inputs
Crosstalk
PAD ON,
GAIN Minimum
CH INPUT GAIN control
CH INPUT PAD switch
0 dBu is referenced to 0.775 V rms.
General Specifications
CH High Pass Filter
Phantom Power
CH PEAK LED
CH SIGNAL LED
Included Accessories
Power Consumption
Dimensions (W x H x D)
Weight
Conditions
20 Hz - 20 k Hz @ +14 dBu, 10 k ohms,
GAIN Maximum
20 Hz - 20 k Hz @ +14 dBu, 10 k ohms,
GAIN Minimum
20 Hz - 20 k Hz @ +4 dBu, 10 k ohms,
GAIN Maximum
20 Hz - 20 k Hz @ +4 dBu, 10 k ohms,
GAIN Minimum
PAD OFF, GAIN Maximum
( Sensitivity = – 60 dBu )
PAD ON , GAIN Maximum
( Sensitivity = – 34 dBu )
PAD OFF, GAIN Minimum
( Sensitivity = – 16 dBu )
PAD ON , GAIN Minimum
( Sensitivity = +10 dBu )
CH IN to CH OUT
@ 1 k Hz
@ 10 k Hz
variable
80 Hz, 12 dB/octave
Turn over /roll-off frequency of shelving : 3 dB below maximum variable level.
+48 V DC is applied to balanced inputs for powering condenser microphones via 6.8 k ohms
current-limiting/isolation resistors.
One red LED per channel. Comes on when post – GAIN signal level reaches + 17 dBu.
One green LED per channel. Comes on when post – GAIN signal level reaches -10 dBu.
Power Supply Cord, Euroblock Connectors ( 3P x 8 ), Rubber Feet ( x 4 ), Owner's Manual
25 W
480 mm x 44 mm x 375.5 mm
4.7 kg
MIN
TYP
MAX
0.1
0.01
– 1
0
0.5
– 0.5
0
0.5
– 128
(68 dB S/N)
– 99
(65 dB S/N)
– 108
(92 dB S/N)
– 82
(92 dB S/N)
64
–90
– 70
44
26
MIC LINE AMPLIFIER
UNIT
%
%
dB
dB
dBu
dBu
dBu
dBu
dB
dB
dB
dB
dB
19
Werbung
Inhaltsverzeichnis
