Abt 8T0800105 Montageanleitung Seite 14

Assembly time: approx. 2 h (without painting and adhesive hardening)
Attention: During assembly, the room, car and part temperature must not be lower than
+15° C. If necessary, condition the car early enough before installing. Below this temperature
a durable adhering cannot be guaranteed.
Attention: Please read the assembly instructions carefully and completely before installing!
It includes important details and information which must be followed before and during the
installation and which help to avoid misunderstandings. Abt Sportsline recommends a
specific dealer's workshop for all assembly work. In case of doubt, please feel free to
contact our technical service at (+49 (0)831 57140-28/-30).
1. Check if the parts are undamaged and delivery is complete by means of the parts list before
painting and installing.
2. Remove the wheels from the front axis.
3. Attention: Turn off the ignition and pull out the ignition key.
4. Remove the wheel-arch inner panels as follows:
19.05.08 / AH
Assembly instructions
Fig. 1: Cover of drive shaft
MA_Kotflügeleinsätze_8T0 800 105 Seite 14 von 24