K&S BASIC KSB 12i S Gebrauchsanweisung Seite 24

REPLACING OR ADDING MOTOR OIL: REPLACING OR ADDING MOTOR OIL:
Upon oil level decrease it is necessary to add the required quantity in order
to provide the correct generator operation. It is necessary to check the oil levels
according to technical maintanance schedule.
ATTENTION - DANGER!
TO DRAIN OIL, PROCEED AS FOLLOWS: TO DRAIN OIL, PROCEED AS FOLLOWS:
1. Place the generator on a flat surface and warm up the engine for several minutes. Stop the engine and turn the
fuel tank cap to the "OFF" position.
2. Remove the motor cover.
3. Place an oil drain tray under the engine.
4. Unscrew the oil drain cap with a hexagon key.
5. Wait for the oil to drain. Tilt the generator for a better result.
6. Add motor oil to a high level.
7. Wipe the oil drain cap with a clean, dry cloth and wipe off any oil spills, if any. Make sure that no dirt, dust, etc.
are caught in the crankcase.
8. Replace the cap.
ATTENTION - DANGER!
Air filter cleaning is to be performed each 50 hours of the generator operation (every 10 hours in unusually dusty
conditions).
CLEANING THE FILTER: CLEANING THE FILTER:
1. Open the clips on the upper cap of the air filter.
2. Remove the sponge filtering element.
3. Remove all dirt deposits inside the hollow case of the air filter.
4. Thoroughly wash the filtering element in warmsoapy water.
5. Dry the sponge filter.
6. Dry filtering element is to be moistened by motor oil and excess oil is to be squeezed out.
Electrode
0,7-0,8 mm
Avoid draining the engine oil immediately after stopping the engine.
The oil is hot and should be handled with care to avoid burns.
Do not tilt the generator while adding oil to the engine. This can
lead to overfilling and damage to the engine.
AIR FILTERTECHNICAL MAINTENANCE
SPARK PLUG TECHNICAL MAINTENANCE
Spark plug is an importaint element providing the correct
engine operation. It has to be intact, without soot deposits
and to have a correct gap.
fill to here
www.ks-power.de/en
11
12
| 23