Designated Use; Care And Maintenance; Operating Temperature Range - WATERPROOF DIVING ULTIMA DRY GLOVE SYSTEM Gebrauchsanweisung

USER MANUAL
These instructions cover the Waterproof Dry Glove System ULTIMA for dry diving suits according to
EN14225-2.

DESIGNATED USE

This Ultima Dry Glove System is approved for Waterproof drysuits with latex wrists and SI TECH QCS
OVAL SYSTEM. In combination with insulating dry glove, the Ultima system will provide your hands with
thermal protection in and under water. Ask Waterproof for suitable dry gloves: info@waterproof.eu.
WARNING!
Before using this system, it is imperative to have received the appropriate dive training and obtained a
diving certi cate issued by an approved organisation. WATERPROOF does not accept any responsibility in
the event of an incident caused due to lack of training, misuse or unsuitable usage.
CAUTION!
Prolonged exposure to heat or UV rays can cause plastic decomposition.
PRE DIVE CHECK
Always dive with wrist seals installed.
Make sure the sealing o-ring is clean and intact before mounting the glove ring.
Check before every dive everything is mounted correctly and gloves and seals are intact.
Check the equalization tube is installed to equalize the pressure between suit and glove.
Make sure you visually check the glove ring is mounted correctly and close to the suit ring on all sides
before diving.

CARE AND MAINTENANCE

Rinse and clean the dry glove system with fresh cold water after each dive. Pay extra attention to the
large sealing o-ring inside the glove ring. Never drop your ring system on any hard surfaces, this may
cause the parts to break. Be extra careful of the sealing parts on the suit ring and glove ring. If it
becomes hard to don and doff, add some Silicone grease to the sealing o-ring.
Replace all o-rings after 30 months or when signs of cracks or damage are visible.
For disinfection please email: info@waterproof.eu

OPERATING TEMPERATURE RANGE

STORAGE
Store away from sources of UV radiation (mainly sunlight). Optimal storage conditions: 65% humidity,
21° C, protected from light and without mechanical, chemical and physical in uences. Inspect regularly
(every six months).
-2° C to 30° C