WATERPROOF DIVING ULTIMA DRY GLOVE SYSTEM Gebrauchsanweisung Seite 11

DISMOUNTING THE SUIT RING
IMPORTANT!
Always use the WP designated tool (included in the box), when dismounting the suit ring, otherwise
damage of the Ultima suit ring, suit PU-ring or seal will occur. NEVER use metal tools like screw drivers!
1. Open a small gap between the suit ring and
the suit by pressing down the back of the suit
arm hard.
2. Gently push down the tool between the ridge
on the suit ring and the suit.
Note the 'hook' on the tool should point away
from the suit! See image.
3. Keep the tool pressed hard to the bottom of
the suit ring and bend the tool towards the suit
arm until it gets loose. Remember to push down
on the back of the suit arm at the same time.
If it is very hard to loosen it, try the tool in the
same groove 3-5cm to the side where you push
it down.
Watch the instruction video on www.waterproof.eu