eta 002895070 Bedienungsanleitung Seite 19

– – Cut off and remove dry and hard clove ends to speed up peeling dramatically. Cut off and remove dry and hard clove ends to speed up peeling dramatically.
We recommend switching off the driving unit in the course of peeling We recommend switching off the driving unit in the course of peeling
–
(after approx. (after approx. 10
cloves already peeled. Then go on peeling the cloves that have cloves already peeled. Then go on peeling the cloves that have
not been peeled so far. Continue with unpeeled cloves, making not been peeled so far. Continue with unpeeled cloves, making
approximately the same cycles, until all cloves have been peeled. approximately the same cycles, until all cloves have been peeled.
When processing large quantities (approx. When processing large quantities (approx. 3 cycles after 60 g
–
stop the peeling process after a time and check whether garlic is stop the peeling process after a time and check whether garlic is
not sticking on the parts of the device. If so, switch off the device, not sticking on the parts of the device. If so, switch off the device,
remove the pieces of garlic peel sticking to the surface of the remove the pieces of garlic peel sticking to the surface of the
components and/or the walls of the bowl. If the inner surface of the components and/or the walls of the bowl. If the inner surface of the
bowl is wet and with sticking pieces of peel, we recommend washing bowl is wet and with sticking pieces of peel, we recommend washing
it with warm water and dry. Then continue peeling other cloves. it with warm water and dry. Then continue peeling other cloves.
– Use garlic of good quality. Preparation (processing) time depends on the quantity, sort and Use garlic of good quality. Preparation (processing) time depends on the quantity, sort and
quality of garlic. Standard peeling time is tens of seconds. quality of garlic. Standard peeling time is tens of seconds.
Food preparation (fig. 4)
The accessories can be used for peeling of almost all sorts of garlic. Remove the shank and
split the garlic bulb into cloves.
(i.e. one "medium-sized" bulb).
Application (fig. 5)
Distribute individual garlic cloves evenly in the drive. Insert the tamper into the filling orifice.
Put the appliance into operation by turning the speed dial to one of the speed levels
appropriate for peeling of garlic cloves. After finishing processing, turn off the appliance
press by turning the dial to position 0 / OFF.
Recommendation
10 - - 15 sec. 15 sec.), removing the lid and taking out the ), removing the lid and taking out the
Maximum quantity of the garlic to be peeled is 60 g
The maximum permitted processing speed is MAX.
3 cycles after 60 g), ),
19 / 39
EN
i