Preparing Milk Froth - Conrad CM5400C-GS Bedienungsanleitung

e) Preparing milk froth
To prepare a cappuccino, brew an espresso in a larger cup and then add milk froth.
Milk froth can also be used to prepare other drinks (e.g. hot chocolate, latte macchiato, etc.).
Milk froth preparation requires some practice, but you can easily learn how to make it after a few tries.
The filter holder (6) must be in place in the machine to prepare milk froth.
• Make sure there is enough water in the water tank (13). Fill the water tank (13) with fresh water up to the MAX
marking.
• Turn the rotary switch (3) to the
• Switch on the appliance by setting the on/off switch (10) to "I". The
indicator (1) flashes.
• The appliance begins to heat up. Once the appliance is heated up, the
• Add about 100 ml of fridge cold milk to a milk frothing jug per cappuccino cup.
The milk frothing jug should be at least 70 mm in a diameter and be capacious enough to hold twice the
amount of milk (milk froth is about twice the volume of the milk).
• Pivot the steam tube (12) with the steam outlet (11) over an empty vessel and turn the rotary switch (3) to
the position.
• Let the condensed water drip off until steam comes out.
• Turn the rotary switch (3) back to the
• Dip the steam outlet (11) into the milk just beneath the surface and hold the milk frothing jug slightly inclined.
• Turn the rotary switch (3) to the
• Hot steam will now come out from the steam outlet (11). Move the milk frothing jug in a circular up and down motion.
Make sure that hot steam or milk does not splash around. Risk of scalding!
• After producing the desired amount of milk froth, make sure you turn the rotary switch (3) back to the
• Pivot the milk frothing jug around in a circle again and tap it with the bottom on a table top or any other hard surface.
This ensures that large air bubbles are removed and froth is distributed evenly.
• The steam outlet (11) and the steam tube (12) should be cleaned after each preparation as described in section
"Care and cleaning".
Keep your hands clear of the hot machine parts.
position.
position.
position.
indicator (2) lights up red and the
indicator (1) glows steadily.
position.
27