General Power Tool Safety Warnings - Makita DFR540 Betriebsanleitung

ENGLISH (Original Instructions)
1. Red indicator
2. Button
3. Battery cartridge
4. Indicator lamps
5. Check button
6. Lever
7. Stopper base
8. Label on feeder box
9. Fenestella
SPECIFICATIONS
No load speed (min
Overall length
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heaviest
combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of residence.
WARNING:
• Only use the battery cartridges and chargers listed above. Use of any other battery cartridges and chargers may
cause injury and/or fire.
Intended use
The tool is intended for screw driving in wood, metal and
plastic.
General power tool safety
warnings
WARNING: Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Save all warnings and
instructions for future reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
Explanation of general view
10. Casing
11. Adjusting knob
12. Switch trigger
13. Reversing switch lever
14. Thumb screw
15. Plane bearing
16. Dust cover
17. Bit
18. Feeder box
Model
Screw strip
-1
)
Net weight
D.C.14.4 V Model
D.C.18 V Model
DFR540
2.0 - 3.0 kg
D.C. 14.4 V
BL1415N/BL1430B/BL1440/BL1460B
BL1815N/BL1820B/BL1830B/BL1840B/BL1850B/BL1860B
DC18RC/DC18RD/DC18RE/DC18SD/
DC18SE/DC18SF/DC18SH/DC18WC
CORDLESS SCREWDRIVER
ENE033-1
SAFETY WARNINGS
1. Hold the power tool by insulated gripping
surfaces, when performing an operation where the
fastener may contact hidden wiring. Fasteners
GEA010-2
contacting a "live" wire may make exposed metal parts
of the power tool "live" and could give the operator an
electric shock.
2. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
3. Hold the tool firmly.
4. Keep hands away from rotating parts.
5. Do not touch the bit or the workpiece immediately
after operation; they may be extremely hot and
could burn your skin.
6. Always secure workpiece in a vise or similar hold-
down device.
19. Screw strip
20. Screw guide
21. Driving position
22. Reverse button
23. Hook
24. Hanging hole
25. Wall
DFR550
4 x 25 - 55 mm
4,000
424 m
2.1 - 3.1 kg
D.C. 18 V
DFR750
4 x 45 - 75 mm
464 mm
2.1 - 3.2 kg
D.C. 18 V
GEB139-2
5