Konig Electronic SEC-ALARM200 Anleitung Seite 4

To disable the alert zone feature:
1. Press [PROG] + MPIN [factory default 1 2 3 4].
2. Press [8] to select Alert Zone.
3. Press [3] to disable for zone 3. The zone 3 LED will flash after selected.
4. Press [PROG] when finished.
Notes: 1) The Motion Sensor is factory default in zone 3.
2) If the Motion Sensor doesn't respond to your movement, try not to move in
front of the sensor for 20 seconds (i.e. no motion is detected in 20 seconds),
then walk again. The Motion Sensor is designed to be triggered only if no
motion is detected for 20 seconds.
Program Emergency Phone Number
During an emergency, the Control Panel can call up to 5 phone numbers to inform you
about an emergency situation. There are 5 phone memories, it will first call phone memory
1, then phone memory 2, etc. It will call phone memory 5 last. Each phone number can
have a redial count up to 9 times, and the emergency voice message can be repeated up
to 9 times. To program phone numbers, follow the procedures below.
Function
Enter program mode by MPIN
Select program phone numbers
Select phone memory
Enter the phone number, then [Arm]
Enter redial count, then [Arm]
Enter message repeat count, then [Arm]
Note: Do not program police, or fire station phone numbers into any of the phone
memories.
Operation - Alarm
Arm
You should arm the Control Panel if you are the last person
to leave the house. To arm, press [Arm], Control Panel will
beep for 45 seconds, this is called the exit delay. You must
leave the house within 45 seconds.
Note: Control Panel can only be armed when no sensor is
triggered. Triggered sensors must be deactivated in
order to successfully arm the system.
Key Description
[PROG] [MPIN]
[1]
[1] to [5]
[Phone Number] [Arm] Phone number
[1] to [9] [Arm]
[1] to [9] [Arm]
4
Note