Bosch EasySpray 18V-100 Originalbetriebsanleitung Seite 25

ner. Observe the manufacturer's disposal information and
the local regulations for disposal of hazardous waste.
Chemicals harmful to the environment may not be disposed
of into soil, groundwater or bodies of water. Never pour
chemicals harmful to the environment into the sewerage sys-
tem.
Troubleshooting
Problem Cause
Spray material does not Spraying capacity too low
cover properly
Clearance to target area too large
Not enough spray material on target area, too
few spray paths sprayed over target area
Spray material too viscous
Spray material runs off after Too much spray material applied
coating
Clearance to target area too close
Viscosity of spray material too low
Spray material applied too often over same
spot
Atomisation too coarse Spraying capacity too high
Nozzle needle (13) contaminated
Spray material too viscous
Air filter (28) heavily contaminated
Excessive paint mist Too much spray material applied
Clearance to target area too large
Spray jet pulsates Not enough spray material in container
Ventilation hole (15) on suction tube (12)
clogged
Suction tube (12) loose
Nozzle cap (9) loose
Air filter (28) heavily contaminated
Spray material too viscous
Spray material dripping at Deposit of spray material on the nozzle cap (9),
the nozzle cap the nozzle needle (13) and the air cap (2)
Nozzle cap (9) loose
No spray material coming Suction tube (12) loose
out of the nozzle cap
Nozzle needle (13) clogged
Suction tube (12) clogged
Ventilation hole (15) on suction tube (12)
clogged
Bosch Power Tools
Storage
– Before putting the fine-spray system into storage, thor-
oughly clean the fine-spray system and allow all parts to
dry completely before assembling them.
If the fine-spray system is not being used, the elastic band
together with the pin on the base unit (19) serve as a prac-
tical storage option for the air hose (17) (see figure ).
If the fine-spray system is not being used, the elastic band
together with the pin on the base unit (19) serve as a prac-
tical storage option for the air hose (17).
Corrective measures
Turn the thumbwheel (5) in the + direction
Reduce spray distance
Apply more spray paths over target area
Dilute the spray material again and carry out a
test-spray run
Turn the thumbwheel (5) in the − direction
Increase spray distance
Add original spray material
Remove spray material; reduce number of
spray paths over same spot
Turn the thumbwheel (5) in the − direction
Clean the nozzle needle
Dilute the spray material again and carry out a
test-spray run
Change the air filter
Turn the thumbwheel (5) in the − direction
Reduce spray distance
Refill the spray material
Clean the suction tube and the ventilation hole
Slide the suction tube all the way onto the paint
channel (16)
Tighten the nozzle cap
Change the air filter
Dilute the spray material again and carry out a
test-spray run
Clean the nozzle cap, nozzle needle and air cap
Tighten the nozzle cap
Slide the suction tube all the way onto the paint
channel (16)
Clean the nozzle needle
Clean the suction tube
Clean the suction tube and the ventilation hole
English | 25
1 609 92A 6FW | (13.12.2021)