Black & Decker BDCH188 Originalanweisungen Seite 7

Injuries caused by touching any rotating/moving parts.
u
Injuries caused when changing any parts, blades or
u
accessories.
Injuries caused by prolonged use of a tool. When
u
using any tool for prolonged periods ensure you take
regular breaks.
Impairment of hearing.
u
Health hazards caused by breathing dust developed
u
when using your tool (example:- working with wood,
especially oak, beech and MDF.)
Vibration
The declared vibration emission values stated in the
technical data and the declaration of conformity have been
measured in accordance with a standard test method
provided by EN62841 and may be used for comparing one
tool with another.
The declared vibration emission value may also be used
@
in a preliminary assessment of exposure.
Warning! The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which
the tool is used. The vibration level may increase
above the level stated.
When assessing vibration exposure to determine safety
measures required by 2002/44/EC to protect persons
regularly using power tools in employment, an estimation
of vibration exposure should consider, the actual condi-
tions of use and the way the tool is used, including taking
account of all parts of the operating cycle such as the
times when the tool is switched off and when it is running
idle in addition to the trigger time.
Labels on tool
The following symbols are shown on the tool along with
the date code: :
Warning! To reduce the risk of injury, the
f
user must read the instruction manual.
Wear ear protectors with impact drills.
Exposure to noise can cause hearing loss.
(Original instructions)
Additional safety instructions for batteries and
chargers
Batteries
● Never attempt to open for any reason.
● Do not expose the battery to water.
● Do not expose the battery to heat.
● Do not store in locations where the temperature may
exceed 40 °C.
● Charge only at ambient temperatures between 10 °C
and 40 °C.
● Charge only using the charger provided with the
appliance/tool.
● When disposing of batteries, follow the instructions
given in the section "Protecting the environment".
● Do not damage/deform the battery pack either by
puncture or impact, as this may create a risk of injury
and fire.
● Do not charge damaged batteries.
● Under extreme conditions, battery leakage may occur.
When you notice liquid on the batteries carefully wipe
the liquid off using a cloth. Avoid skin contact.
● In case of skin or eye contact, follow the instructions
@
below.
Warning! The battery fluid may cause personal
injury or damage to property. In case of skin
contact, immediately rinse with water. If redness,
pain or irritation occurs seek medical attention. In
case of eye contact, rinse immediately with clean
water and seek medical attention.
Chargers
Your charger has been designed for a specific voltage.
Always check that the mains voltage corresponds to the
@
voltage on the rating plate.
Warning! Never attempt to replace the charger
unit with a regular mains plug.
● Use your charger only to charge the battery in the tool
with which it was supplied. Other batteries could burst,
causing personal injury and damage.
● Never attempt to charge non-rechargeable batteries.
ENGLISH
7