Inhaltsverzeichnis
Werbung
Be very careful when shortening the silicone strap!
Shortening of the silicone strap should be carried out symmetrically and on a
step-by-step basis until the desired strap length has been achieved. If asymme-
tric shortening is necessary, the body-facing side should be shortened more.
Keep trying on the silicone strap in between. Shortening on both sides by one
hole in each case corresponds to a reduction of the total size by 10 mm – a
one-sided length reduction of 5 mm.
Please note: To use the strap-length quick adjustment, the stud on the silicone
strap half without the SINN logo must always be in position
always located in position
1
. Use the stud to determine the margin for the
strap-length quick adjustment so that you will be able to compensate for a
changed wrist circumference (e.g. due to temperature-related variations). To
use a minimum margin, at least four positions should always be occupied on the
silicone strap half without the SINN logo, in the following sequence: Metal pin
, stud
and two additional metal pins
1
2
2
, a metal pin is
(see diagram).
3
4
4
3
2
1
First, shorten the silicone strap for the strap-length quick adjustment (without
SINN logo). To do this, sever the silicone strap with a knife or a pair of scissors
centrally between two boreholes. After severing the silicone strap, remove the
stud and replace it at position
2
boreholes must be filled with a metal pin.
If a further shortening is necessary, you will then need to carry this out on the
other silicone strap half (with SINN logo). Sever the silicone strap again with a
knife or pair of scissors – centrally between two boreholes. After severing the
strap, replace the outermost metal pin at position
and the reattach the folding clasp to the silicone strap. To do this, insert the
silicone strap half with the spring bar on one side into the hole in the folding
clasp. Using the strap replacement tool, press on the plate on the opposite side
of the spring bar to position it in the hole. Pull on it to check whether the folding
clasp is secure.
A
Plate
after first removing the metal pin. All other
1
with the spring bar
Plate
A
A
1
25
Werbung
Inhaltsverzeichnis
