Installation Instructions; Symbol Description; Flow Diagram - HANSGROHE Metris Classic 31078-Serie Gebrauchsanleitung, Montageanleitung


Safety Notes
Gloves should be worn during installation to prevent

crushing and cutting injuries.
The shower system may only be used for bathing,

hygienic and body cleansing purposes.
The hot and cold supplies must be of equal pressu-

res.

Installation Instructions

• The fitting must be installed, flushed and tested after
the valid norms.
• If the instantaneous water heater causes problems or
if you wish to increase the water flow, the EcoSmart
(flow limiter) located behind the aerator can be
removed.
Technical Data
This mixer series-produced with EcoSmart
limiter)
Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Hansgrohe mixers can be used together with
hydraulically and thermically controlled continuous flow
heaters if the flow pressure is at least 0,15 MPa.

All manuals and user guides at all-guides.com
English
®
max. 1 MPa
0,1 – 0,5 MPa
1,6 MPa
max. 80°C
65°C
Assembly see page 31 + 32

Symbol description

To adjust the hot water limiter on single lever
mixers, please see page 33. No adjustment
is necessary when using a continuous flow
water heater.
Do not use silicone containing acetic acid!
Dimensions (see page 34 + 35)
®

Flow diagram

(see page 34 + 35)

(flow

Spare parts (see page 38)
Special accessories
special tool (58085000) order as an extra
Installation kit order as an extra
Operation (see page 36)
Cleaning (see page 37) enclosed
brochure
Test certificate (see page 39)
with EcoSmart
®
without EcoSmart
®