Product Information; Mounting Accessories - Ferm 326110 Gebrauchsanweisung

SPARE PARTS LIST FBE-6E
REF.NR. DESCRIPTION
001 SWITCH
002 HANDLE
003 LOCKING BOLT
004 COLLET NUT
005 CUTTING DEPTH STOP
006 CLAMPING LEVER
007 ELECTRONIC SPEED CONTROL
008 ROTOR
009 STATOR
010 CARBON BRUSH (SET)
011 DUSTEXTRACTING ADAPTOR
015 GUIDE ROD
016 GUIDE FRAME
- OPEN ENDED SPANNER
- OPEN ENDED SPANNER (COLLET NUT)
- SPRING COLLET 6 MM
38

PRODUCT INFORMATION

13
FERM NR.
302008
302003
302002
312009
302009
302010
302011
302012
302013
12
302014
11
302015
10
302005
302006
9
302016
312011
312012
Fig. A.
This machine has been designed for professional routing
of wood, wood products and plastics.
1 on/off switch
2 machine clamp screw
3 clamping lever for depth adjustment
4 handle
5. collet bracket
6 collet nut
7 router base
8 opening for parallel guide
9 locking bolt for parallel guide
10 revolver-depth stop
11 scale cutting depth
12 locking bolt depth stop
13 adjusting wheel electronic speed control
Ferm Ferm

MOUNTING ACCESSORIES

1
2
3
Fig. B.
4
Prior to mounting an accessory always unplug
5
the tool.
6
Mounting and removing cutters.
Only use cutters with a shaft diameter which corresponds
7
with the size of the collet. Only use cutters which are suited
for the maximum speed of the machine. The cutter diame-
8
ter should not exceed the maximum diameter (see 'Tech-
nical specifications').
• Place an open-ended spanner on the collet bracket
and use the second spanner to loosen the collet nut.
• Place the cutter shaft in the collet.
• Tighten the collet nut so that the cutter is locked pro-
perly.
• Open the collet nut when you want to replace a cutter.
Wait until the machine has come to a complete
standstill and the cutter has cooled down before
replacing a cutter.
3