Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
12 |
EN
Start the baking time
Press the "START" key to start the baking time clock.
The baking time will count down until it reaches zero. The system will sound a warning signal at least 4
seconds from the end to indicate that baking is almost finished. The warning will stop when the clock finishes
counting down.
Removing the baked product
Release the plate closure handle and lift the cover.
Remove the baked product from the baking plate.
If you wish to repeat the baking time (new countdown), press the "START" key again.
End of production
When production has finished, press the "OFF" key and the LED below the text will turn on. The light on
the display will turn off, the plate heating phase will finish and the machine will no longer be able to be
programmed.
The will plates return to room temperature about 30-40 minutes after the "OFF" key has been pressed.
Turning off the machine
After pressing the "OFF" key, the LED will turn ON and you can switch off the voltage supply to the machine
by turning the master switch knob at the back of the machine to the "O" position. The light on the display and
the keys will go out as there is no more voltage.
IMPORTANT: Always pull the plug and the lead out of the socket.
To make it easier to memorise baking temperature, time and the type of plate (with reference to the type of
product being baked) a table is supplied with the machine where the user can record reference data.
Maintenance / Cleaning
We recommend:
• cleaning the plates by washing them with hot water and non-corrosive products commonly accepted in
HACCP (disinfectants, etc). Be careful not to scratch the surface since it is covered in PTFE;
• periodically empty the crumb drawer at the back of the machine.
Technical features
• Electricity voltage: 220/240 volt - 110/380 volt on demand
• Absorbed power: 3200 watts
• Machine measurements: mm 440x530x420 h
• Machine weight: 28 kg
• Weight of plates (pair): 11 kg
• Material: AISI 304 steel conforming to Ni/Cr migration
Packaging (measurements and weight):
• machine:
• dimensions: mm 480x660x460 h
• weight with machine: 32 kg
• plates:
• dimensions: mm 420x380x120 h
• weight with plates (pair): 12 kg
Accessories
Interchangeable pairs of male and female plates can be supplied on request.
The plates are covered in a special PTFE material that is specific for products that come into contact with
foodstuffs.
EN
| 13
Werbung
Inhaltsverzeichnis
