Cleaning And Maintenance; Troubleshooting; Technical Data - BOMANN VS 2195.1 Bedienungsanleitung, Garantie

Cleaning and Maintenance

WARNING:
 Always disconnect the appliance from the power
supply before cleaning and user maintenance.
 Do not use steam cleaners for cleaning the appli-
ance; moisture could enter electrical components.
Risk of electric shock! Hot steam could damage
the plastic parts.
 The unit must be dry before restarting operation.
CAUTION:
 Do not use a wire brush or other sharp, abrasive
items.
 Do not use any acidic or abrasive detergents.
 Do not damage the refrigerant circuit.
Cleaning the appliance including interior
 Clean the appliance interior, the exterior surfaces,
the accessories and the door seal regularly with
warm water and mild detergent; or with a clean,
damp microfiber cloth without cleaning agent.
 Remove the appliance content and storage it at a
cool location.
 Clean the thaw water discharge channel / opening
carefully e.g. with a pipe cleaner.
 After everything was thoroughly dried, you can
restart the operation.
Defrosting
CAUTION:
Never use metal objects (e.g. knifes) to remove ice
from the evaporator. Otherwise it can be damaged.
The appliance has an automatic defrosting system.
During defrosting water drops drains off at the back
of the cooling chamber. The thaw water running
through a channel, is collected in a drip tray located
on the compressor, where it will evaporate. Make
sure the water discharge opening does not get
clogged. A light formation of ice on the interior back
during operation is normal.
Changing the bulb
CAUTION:
Do NOT remove the cover of the interior light.
The LED light may be replaced / repaired in case of
failure / defect only by an authorized specialist.

Troubleshooting

Before you contact an authorized specialist
Problem Cause / Action
Unit is not ∙ Check the power supply / tem-
working perature setting / ambient temper-
properly or ature. ∙ Unblock the ventilation
at all openings, install the unit freely.
Loading is ∙ Check the temperature setting /
too warm ambient temperature. ∙ Open the
door only as long as necessary.
Loud noise ∙ Check the appliance position.
during opera- ∙ See the section "Operating
tion noise".
Water on the ∙ Check the temperature setting /
unit bottom water discharge channel or open-
ing.
Light does ∙ Check the power supply.
not work ∙ See "Changing the bulb".
NOTE:
If a problem persists after following the steps above,
contact your trader or an authorized technician.

Technical Data

Climate class SN/N/ST/T: this appliance is intended
to be used at ambient temperature ranging from
10°C to 43°C.
Electrical connection............................................
Power voltage: .........................220-240 V~ / 50 Hz
Rated power: ...............................................70 W
Rated current: ..............................................0.4 A
21