Optional Connections - Unify OpenScape Desk Phone CP400T Installations- Und Kurzanleitung

Installation of the telephone
See also overview on page 2.
Desk Installation
By mounting the stand on the telephone using the long or short end
you can select between 20° and 45° tilt angle:
long end: 20°
1. Place the phone upside down on a soft surface and remove all
cables from the phone except the handset cord d .
2. Insert the stand along the L-shaped bars on the base of the tele-
phone as shown.
3. Slide the stand to the stop at the left until it locks into place.
4. Plug the U
P0/E
.
A

Optional Connections

If desired, you can connect further devices to your phone (see also
overview on page 2):
USB slave for PC connection (1st party CTI)
B
Connection to Headset
D
Connection to Key Module
E
If further settings are required for correct operation of the telepho-
ne, please contact your administrator.
cable into the socket on the bottom of the phone
short end: 45°
9